This controller is so small, you may think we forgot to put it in the box. With the buttons right on it, you can choose among Auto, Mode, and Speed settings for your WS2812 Total Control Lighting pixels. This controller has no remote control pad, but can run at DC 5-6 V, giving you more options for using battery power.
This super-sleek controller and RF remote control pad works with our WS2812 Total Control Lighting pixels. It can drive up to 2,048 pixels 50 meters away with 300 pre-programmed patterns.
This controller runs on DC 5-6V.
Please Note: Special care needs to be taken in the charging and discharging of LiPo batteries. These are of the highest quality and work perfectly in all of our projects, but unfortunately are not returnable.
This charger can be used to recharge your Lithium Polymer batteries. Small, lightweight, and able to draw power from any DC 12V source, including your car battery, you can recharge your lithium batteries on the go. Use the included alligator clips to power from a battery; to power using house current, you'll need an AC adapter (see related item in detailed description).
Input: 10.0 - 15.0V, Output: 800mA. Charges 2-cell (7.4V) and 3-cell (11.1V) lithium batteries. Comes with alligator clips.
Your future is so bright, you'll need to wear shades! The tiny driver for these sunglasses is mounted discreetly on the arm -- no wires to dangle or tangle. Modes are off, slow blink, fast blink, and full fun. Glows with 2 CR2032 batteries, not provided. PLEASE NOTE: Remove the batteries when storing to prevent their draining down.
For extreme amusement only!
A strand of LEDs as close as we've ever come to droplets of light. Practically weightless and otherwise invisible, they'll give any project an ethereal quality.
20 tiny LEDs are spaced every 4" over a strand of wire more than 6 feet long. You can weave it through your clothes, your hair, or anything your choose.
The battery pack holds 3 AA batteries (not included) and has an on/off switch. The RGB strand lights in a varied blink mode only; every other strand of color lights in constant mode only.
The battery door is pretty secure by itself, but for extra security, use the small phillips screw that comes with it (you'll need a small phillips screwdriver).
We've been as impatient as you to get these back in stock and now they're here, brighter and better than ever!
These flexible, flat ribbons have a glowing area that's 1 meter long by almost 3/4" wide. With a connector at either end, you can cut the ribbon and use it as two separate pieces, or attach them end-to-end.
One plug & play wire-side connector is included with each ribbon. Additional connectors can be ordered separately for $2 each
NOTE: To figure out which drivers are powerful enough to light up your ribbons, use one ribbon = 40ft of Cool Neon EL Wire. Be sure to use a regulated power supply, such as batteries or the AC 1.2A Regulated Power Adapter (ACBB) with a 12v driver.