This connector will let you run your RGB LED controller with batteries, making the RGB LED strips easily portable. With this accessory, you can use RGB LED strips on costumes, in a car, on outdoor art, or anything you can think of.
One end has a 5.5*2.1mm center-positive barrel jack that plugs into the controller (Long or Short). The other end has a 9v battery snap which you can attach to 12vDC battery power, such as our 8AA battery cage.
Base price: $5
This cage easily attaches to the 9V snap on many of our Cool Neon drivers and sequencers, our DC 12V Rope Light connector, and our RGB LED controllers (with a barrel connector sold separately).
Please note exceptions: This cage should not be used with the 9V Variable Speed Driver or the 9V snap in the internal compartment of the CAT-09 Sequencer (instead, attach the battery cage to the port on the outside of the sequencer with the included connector).
Dimensions: 1 1/8" x 1 1/8" x 4 1/4"
Base Price: $2.00; batteries not included.
Replaces the 2500mA power supply for $5 less!
Use with our Y Barrel Connector to power your LED strips at more than one insertion point for consistent lighting throughout your project.
Replaces the 12V 2500mA adapter at no additional cost!
This plug & play amplifier lets you control and power more lights in your RGB LED project. To the same Controller and Power Supply, you can now add one Double Density 5m roll (for a total of two) or two Single Density 5m rolls (for a total of 4).
This amplifier comes with screw mounts with two connections that are ready to plug into your project:
1) our standard flat 4-pin female connector that plugs into the male connector on RGB LED strips
2) a barrel connection for our 12v power supplies (house current or 12vDC battery connector).
Please Note: Special care needs to be taken in the charging and discharging of LiPo batteries. These are of the highest quality and work perfectly in all of our projects, but unfortunately are not returnable.