LED, pixels, individually addressable, WS2812, total control lighting, tcl, wireless, controller, economy
These beautiful pixels combine the small size and low profile of the WS2812 chip with supple jumper wires to bring you strands of individually addressable LEDs that are perfect for costumes!
Strands of 50 pixels are offered in two lengths:
6cm jumper length (~ 2 1/2" center to center), total length ~ 10 feet
12cm jumper length (~ 4 7/8" center to center), total length ~ 20 feet
Each strand comes plug & play with a male round 4-pin TCL connector at the beginning and female one at the end.
Note: We highly recommend putting a dab of clear silicon on the back of each chip before working with these pixels. Doing this will help to protect the contact solder points from the tugs and pulls of costume wear. Or even better! Get 5ft of clear heat shrink and cut it into 1.25 inch pieces- slide them down and shrink them down with a heat gun over each pixel.This option make them VERY Durable!
This strip runs on DC 5-6V. It has no silicon coating and isn't weatherproof.
Newly available: if you order a quantity of 4, we'll ship them as one continuous 2-meter strip encased in a water-resistant silicon sleeve completely plug & play: female barrel connector power input at both ends, our 4-pin male connector at the beginning, and a 4-pin female connector at the end for continuous operation of multiple strips.
256 individually addressable RGB LEDS are arranged in a 16 x 16 grid for a mind-blowing display of color and light. This flexible flat panel measures 6 3/4" x 6 3/4". Enjoy countless hours of beautiful patterns with a wireless controller, your own Arduino programming, or programs that you write for our Elite or Pro Controllers with our free software.
These flat panels run on DC 5-6V. They have no silicon protection and aren't weatherproof.
This super-sleek controller and RF remote control pad works with our WS2812 Total Control Lighting pixels. It can drive up to 2,048 pixels 50 meters away with 300 pre-programmed patterns.
This controller runs on DC 5-6V.
This controller is so small, you may think we forgot to put it in the box. With the buttons right on it, you can choose among Auto, Mode, and Speed settings for your WS2812 Total Control Lighting pixels. This controller has no remote control pad, but can run at DC 5-6 V, giving you more options for using battery power.
Custom solder joint for a new RGB LED Roll. Custom Soldering is never more than a one-week turnaround.
Each 4-point soldered connection is considered one solder joint. Connectors are sold separately.