We've been as impatient as you to get these back in stock and now they're here, brighter and better than ever!
These flexible, flat ribbons have a glowing area that's 1 meter long by almost 3/4" wide. With a connector at either end, you can cut the ribbon and use it as two separate pieces, or attach them end-to-end.
One plug & play wire-side connector is included with each ribbon. Additional connectors can be ordered separately for $2 each
NOTE: To figure out which drivers are powerful enough to light up your ribbons, use one ribbon = 40ft of Cool Neon EL Wire. Be sure to use a regulated power supply, such as batteries or the AC 1.2A Regulated Power Adapter (ACBB) with a 12v driver.
Cutting a Custom Contour:
With the connector pointing towards you with the illuminated size down, you can cut the right side of the ribbon. You can cut very close to the electrode on the left but if you cut past it, the ribbon will not light past this point.
When soldering ribbon: there is a 4 pin connector. Cut the long end of a wire-side connector so that both wires are equal length. Solder one wire to the 2 pins on the left side and the other wire to the 2 pins on the right.
1 Ribbon takes 350ma at 12vdc. 2 ribbons take 480ma at 12vdc.